Downing's WebCam Alton Bay

shurbinator · 03-02-2009, 12:39 PM

It has been a while since I posted a comment about Downing’s Landing Webcam. We now have four cams set up at Downing’s Landing, Alton Bay NH.

I waited to reply until we had the cams set up on a webpage so you can view them all at the same time. The site has additional information about Downing's Landing and more will be added. Please look around and help us improve the website. Here is the address of the cam page www.downingslanding.com

If you have any suggestions for the webcams, and/or Downing’s landing website, please use the email address listed on cams webpage.

Please remember, Downing’s Landing webcams were purchased and installed by and for the Downing’s. They may be relocated from time to time – the images you see through the cams are the images the owners are choosing to view. Your thoughts are welcomed.

Shurbinator

03-02-2009, 12:39 PM	#15
shurbinator Junior Member Join Date: Nov 2008 Posts: 2 Thanks: 0 Thanked 11 Times in 1 Post	Update to Downing's Webcams It has been a while since I posted a comment about Downing’s Landing Webcam. We now have four cams set up at Downing’s Landing, Alton Bay NH. I waited to reply until we had the cams set up on a webpage so you can view them all at the same time. The site has additional information about Downing's Landing and more will be added. Please look around and help us improve the website. Here is the address of the cam page www.downingslanding.com If you have any suggestions for the webcams, and/or Downing’s landing website, please use the email address listed on cams webpage. Please remember, Downing’s Landing webcams were purchased and installed by and for the Downing’s. They may be relocated from time to time – the images you see through the cams are the images the owners are choosing to view. Your thoughts are welcomed. Shurbinator __________________ "Man cannot change the direction of the wind, he can only adjust his sails" Last edited by shurbinator; 03-02-2009 at 12:49 PM. Reason: Grammar

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

The Following 11 Users Say Thank You to shurbinator For This Useful Post:
fpartri497 (03-03-2009), hazelnut (03-02-2009), LAND HO! (03-19-2010), mcdude (03-02-2009), moose tracks (03-03-2009), robmac (03-03-2009), Ropetow (03-25-2009), Senter Cove Guy (03-02-2009), SIKSUKR (03-03-2009), Sunset Bob (03-04-2009), trfour (03-02-2009)