View Single Post
Old 10-01-2019, 09:48 PM   #15
Denny Crane
Senior Member
 
Join Date: Mar 2010
Posts: 85
Thanks: 25
Thanked 21 Times in 17 Posts
Default Update

Next round! My engine started beautifully and kept running this time, however gas kept pouring out of the hole in the top hole front face between the 2 carburetors, mostly the top carburator. The primer hose goes into the top of each carberator. I did change the primer solenoid parts, not the whole solenoid. The gas kept flowing down the front face.
I checked the compression again after it ran, full throttle, and each cylinder was once again 60psi. I will admit the compression kit is from harbor freight.
I may be at my limit here, but I'm close.
Sorry the pic is upside down.
Attached Images
 

Last edited by Denny Crane; 10-01-2019 at 10:27 PM.
Denny Crane is offline   Reply With Quote