View Single Post
Old 08-13-2022, 08:39 PM   #21
John Mercier
Senior Member
 
Join Date: Jun 2021
Posts: 2,909
Thanks: 2
Thanked 523 Times in 431 Posts
Default

Does your owner's operation manual have a clause like this?

''NOTE: Periodically on the initial start-‐‐up or after the unit has been stored for a
long period of time, the float for your “Low Oil Shutdown” system will stick to the
bottom of the oil pan. Locate the two (2) wires to the Low Oil Sensor Diode (figure
“Low Oil Sensor Diode” to the right) located on the side of the engine block. Unplug
these wires and, only after ensuring the engine is full of oil, start the engine and
allow to run until warm (normally 20 minutes, as this will heat the oil and release
the float on the Low Oil Shutdown System). Then re-‐‐plug the wires to the terminals
on the Low Oil Shutdown Sending Unit.''
John Mercier is offline   Reply With Quote