View Single Post
Old 03-26-2022, 06:15 PM   #32
thinkxingu
Senior Member
 
thinkxingu's Avatar
 
Join Date: Jul 2014
Posts: 5,939
Thanks: 1,152
Thanked 1,959 Times in 1,210 Posts
Default

Quote:
Originally Posted by DickR View Post
Your pictures show what I was describing. The first two small pieces of kindling go in front to back ("N-S"), other kindling on top so as to provide air space to get the blaze going, and larger splits on top of that pile, diagonally, N-S, and E-W to provide stability as the kindling burns through and the pile settles. But I'm not putting in a full firebox load, as in your pictures. Also, my firebox (inside the bricks) is just over 17" deep (N-S) by just over 13" wide (E-W). It's a Quadrafire 2100 Millenium. Also, mine has the primary air low in front and the secondary tubes up top in the middle. After I get the stove up to temperature, I close the primary air control and the stove is running on "secondaries." The heat of the process makes the wood undergo pyrolysis, and the gases combine with the superheated air from the tubes, igniting the mixture.
You sure on those measurements? The schematic online shows that the front door is 13", which means you must have at least 16" inside and probably closer to 17". There's very few (new) stoves that don't take at least 16" logs.

Sent from my SM-G950U using Tapatalk
thinkxingu is offline   Reply With Quote