Quote:
Originally Posted by AC2717
I have two snaps (on screws) that have come out of the side of the of my boat, and I have tried an adhesive to try and fill the hole with the screw snap but it has not worked.
Does anyone have any ideas or what have you done in the past.
|
I have done this many times…clean the hole good to remove all the old adhesive you tried or drill a slightly larger hole. Then use JB Weld…you can get it in white, black and I believe gray. Fill the hole with JB using a toothpick. Let set up and shave off excess. Redrill proper size hole for snap. Obviously keep your repair area smaller than your snap perimeter so it’s not seen.
Good Luck!
Dan