Winnipesaukee Forum - View Single Post

thinkxingu · 08-24-2019, 11:56 AM

Hi!
Our new park model trailer has an aluminum underbelly with all entry/exit points (power/propane/plumbing) taped up with aluminum tape. I think we're good to keep mice out on that end.
The AC ductwork, however, is only a couple inches off the ground before turning up into the trailer. Though most of the flexible duct is enclosed in solid duct, the couple inches at each end are just the flexible duct wrapped with aluminum tape. Because of the spacing, it's hard to get it wrapped well. Anyone have ideas on what else I could use to wrap that small section to keep the mices from chewing through?

Thanks!

Sent from my SM-G950U using Winnipesaukee Forum mobile app

08-24-2019, 11:56 AM	#1
thinkxingu Senior Member Join Date: Jul 2014 Posts: 5,946 Thanks: 1,154 Thanked 1,963 Times in 1,213 Posts	Keeping AC Ductwork Mice Free Hi! Our new park model trailer has an aluminum underbelly with all entry/exit points (power/propane/plumbing) taped up with aluminum tape. I think we're good to keep mice out on that end. The AC ductwork, however, is only a couple inches off the ground before turning up into the trailer. Though most of the flexible duct is enclosed in solid duct, the couple inches at each end are just the flexible duct wrapped with aluminum tape. Because of the spacing, it's hard to get it wrapped well. Anyone have ideas on what else I could use to wrap that small section to keep the mices from chewing through? Thanks! Sent from my SM-G950U using Winnipesaukee Forum mobile app