Winnipesaukee Forum - View Single Post

Diver1111 · 10-13-2008, 08:13 PM

ScubaJay,

Try these coordinates-rough but it should do:
N/43 36.677 and W/71 27.461

Normally I'd lock on to its position by moving the cursor on my screen over the TOI/target of interest and get Lat/Lon that way but I was just roughing it last time and not doing it the way I normally would.

I suggest dropping a flag at these coordinates as a reference point. Then move around it using your 2D fishfinder. Given the flat bottom and the fact this thing has about 7 foot high sides and is 90 feet long even using 2D it should show up. The moment you see serious altitude on your screen immediately drop anchor-it will probably land on the deck.

10-13-2008, 08:13 PM	#5
Diver1111 Senior Member Join Date: Jun 2005 Location: Exeter NH Posts: 603 Thanks: 0 Thanked 1,032 Times in 227 Posts	Lat/Lon of the Pile Driver ScubaJay, Try these coordinates-rough but it should do: N/43 36.677 and W/71 27.461 Normally I'd lock on to its position by moving the cursor on my screen over the TOI/target of interest and get Lat/Lon that way but I was just roughing it last time and not doing it the way I normally would. I suggest dropping a flag at these coordinates as a reference point. Then move around it using your 2D fishfinder. Given the flat bottom and the fact this thing has about 7 foot high sides and is 90 feet long even using 2D it should show up. The moment you see serious altitude on your screen immediately drop anchor-it will probably land on the deck.