Thread: Second anchor
View Single Post
Old 07-18-2013, 08:16 PM   #15
Dave R
Senior Member
 
Dave R's Avatar
 
Join Date: Jul 2004
Posts: 2,985
Thanks: 246
Thanked 744 Times in 444 Posts
Default

[QUOTE=Par Four;208255]
Quote:
Originally Posted by Dave R View Post
C
..l I use 4 feet of 1/4" chain and about 50 feet of 3/8" nylon 3 strand for a rode. I bet the whole thing cost me less than 40 bucks.


http://www.overtons.com/modperl/prod...SHOPPING_81320[/

Your boat is quite a bit heavier, and you may do a whole lot more fore&aft anchoring than I, but I just tie directly to the anchor for the stern anchor.

I'm pretty conscious of being a trying to be a good citizen on the water always, but especially when in close proximity at a sand bar. I watch the boat almost continually and I've not seen the need for chain. It seems just fine as a direct tie, and I might typically have 30-40' of rode out there off the stern.

You're right, the whole set up is very inexpensive and works great
I suspect you are right about the chain, but I just can't be seen with no chain in my rode, it just feels wrong...
Dave R is offline   Reply With Quote