Winnipesaukee Forum

Winnipesaukee Forum (https://www.winnipesaukee.com/forums/index.php)
-   Automotive (https://www.winnipesaukee.com/forums/forumdisplay.php?f=40)
-   -   92 Miata clutch (https://www.winnipesaukee.com/forums/showthread.php?t=22063)

TriDad 06-03-2017 10:49 AM

92 Miata clutch
 
I have a 92 Miata that needs to have the clutch adjusted. I'm not familiar with the garages up here.

Where would you recommend taking it?

[edited] we are in Gilford

Sent from my iPhone using Tapatalk

jbolty 06-03-2017 11:35 AM

where are you located?

TriDad 06-03-2017 11:52 AM

That would help... Gilford on Laconia line


Sent from my iPhone using Tapatalk

NH.Solar 06-05-2017 05:15 PM

Miatas have hydraulically engaged clutches and I don't know if they are are adjustable.
Is your Miata normally stored all winter? If that is the case you may just need to add some brake fluid to your clutch. Open the hood and just in front of the driver's position you will see two translucent reservoirs, the larger is for your brakes and the smaller one for your clutch. Be sure that both are between the low and full marks. I hope that is all it is!

Bob M 06-06-2017 02:20 AM

Miata Seat Covers
 
TriDad,

Sent you a private message.

Bob M

loony 06-06-2017 04:59 PM

I own a '95 Miata, and yes they have a hydraulically actuated clutch. The slave cylinder gets leaky and with a lack of fluid can prevent the clutch from fully disengaging. Easy replacement, cost $20-$30. The most difficult part is bleeding air out of the system.
If your clutch is slipping, than that a whole other story.

TriDad 06-07-2017 02:30 PM

Harmon Motors
 
Quote:

Originally Posted by loony (Post 279723)
I own a '95 Miata, and yes they have a hydraulically actuated clutch. The slave cylinder gets leaky and with a lack of fluid can prevent the clutch from fully disengaging. Easy replacement, cost $20-$30. The most difficult part is bleeding air out of the system.
If your clutch is slipping, than that a whole other story.

Good diagnosis. It was the slave cylinder. It needed to be replaced.

I brought it to Harmon Motors in Gilford. Great people. They diagnosed it immediately and did the quick repair for a very reasonable price.


All times are GMT -5. The time now is 04:36 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.