Go Back   Winnipesaukee Forum > Blogs > Justenuff
Home Forums Gallery Webcams Blogs YouTube Channel Classifieds Calendar Register FAQDonate Members List Today's Posts

» Site Navigation
» Quiz
» Articles - Information
» Recent Forum Threads
Storage Question
Yesterday 07:17 AM
by SAMIAM
Last post by TomC
Today 02:47 PM
4 Replies, 658 Views
First Cyanobacteria...
06-13-2024 09:51 AM
Last post by stingray
Today 02:29 PM
118 Replies, 8,708 Views
Dead possum in lake
Yesterday 06:42 AM
by nj2nh
Last post by Biggd
Today 01:06 PM
7 Replies, 1,012 Views
Huge Commercial Project...
01-30-2024 03:29 PM
Last post by Little Bear
Today 12:25 PM
192 Replies, 48,753 Views
Hunter’s Shop n’ Save...
04-13-2024 08:43 AM
Last post by tis
Yesterday 03:45 PM
35 Replies, 8,679 Views
» Made in USA
  1. Old Comment

    Anticipation

    Ok, finally got over the Anticipation and took the boat up to Lake Winni over the long weekend. For those interested:
    *Yes the trailer held up and did beautifully. I need to investigate why one tire is losing pressure gradually, but we had no problems.
    *The old truck did fine, with it's (almost) bald tires, after a visit to the shop. They replaced the serpentine belt and idler, and got rid of the buzzzzzzz.
    *This year my first mate and I were able to rig up the mast with minimal problems, no bent or broke equipment. We did as Wayne from Fays one technical question (Wayne: thanks for the help!). Boat was launched with no problems.
    *Motor, oh yes. I had taken the motor over for service, and it started right up. About half way to the mooring, it decided to act up again. I believe that we are having some gas issues, maybe ethanol issues with a 23 yr old motor? Wish I could locate a list of non-ethanol stations. Do all marinas have straight gas only, no ETOH?
    Funny story: I pulled up to the mooring facing a stiff headwind and pulled the ball, grabbing the lead and hooking it to the front of the boat. After I was sure that I was on, I went to the back, cut the motor, and noticed that the bow was turning away from the mooring ball. I had hooked the end of the secondary line to the front of the boat, and it wasn't connected to the ball. Started the motor (again, whew!) and pulled up to the ball, pulled it again and found the primary line, checked the connection to the chain, hooked it to the bow and waited until the ball moved with the boat motion before cutting the engine.
    Now to work on the gas/motor problem next week.
    Posted 05-28-2008 at 06:58 AM by Justenuff Justenuff is offline

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 03:00 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

This page was generated in 0.51701 seconds