View Single Post
Old 04-23-2012, 01:27 PM   #7
Woodsy
Senior Member
 
Join Date: May 2004
Location: Weirs Beach
Posts: 1,946
Thanks: 80
Thanked 968 Times in 431 Posts
Default

dippasan....

A boat porpoises due to overtrimming the drive relative to the speed the boat is traveling. Too slow + too much positive trim = porpoising.

Another cause for porpoising is a nasty hook in the hull. You can take a long straight edge to the bottom of the boat to see if this is the case. I doubt it though. If thats the case its not a cheap fix.

You didnt say who made the powertrain... I assume its OMC? In anycase I would follow the advice above and look at changing your prop. Not sure what the prop size was originally, (prob somewhere around a 14.25 x 21) but if you can find that out that would be a good place to start. Def go with a 3 blade stainless steel prop over the original aluminum. You can have some cup added to the prop to allow more bow lift.

Here is a link to Four Winns website... http://www.fourwinns.com/past_produc...20(p12-16).pdf

Woodsy
__________________
The only way to eliminate ignorant behavior is through education. You can't fix stupid.
Woodsy is offline   Reply With Quote
The Following User Says Thank You to Woodsy For This Useful Post: