Quote:
Originally Posted by bigdog
Hi everyone,
Just got boat back from marine repairs.Had the following replaced:
3 Bellows replaced: U-Joint, Exhuast, Shift Cable
Gimbal Bearing
All gaskets and O-Rings
All parts were included in a kit referred to as 'Transom Seal Kit'.
They also replaced Shift Cable-the piece which passess through transom to O/D.
Also, had Trim Limit/Sender Pucks replaced.
All parts lubed during re-assembly.
All new parts were used, 'Sierra' brand.
Parts & Labor & Tax $600.
Took boat out for a run today to test for leaks. All appears well and bilge is completely 'dry' !
Have another same issue, which I thought was solved with engine stalling,
appears to have reared it's ugly head again ! Have posted in another thread.
Thanks again for the info. about the bilge problem, this one is hopefully behind me !
Thanks,
Bigdog
|
Good news Bigdog. Sounds like you got a bargain. Stalling when shifting. Since they replaced the shift cable between the O/D and the linkage on top of the engine, I suspect all it needs is a
followup shift cable adjustment on top of the engine. A five minute job. It's easiest with the boat in the water.